Vtp revision not updating Chatrall sex com
VTP version 2 mode is disabled across the entire network. Buck Weet Burt, The revision number on the vtp server goes up in increments of one everytime a change is made to the on the vtp server and this is what the clients in the same vtp domain use as a check point to update their vlan database.
I checked the configuration revision number was not higher than the vtp server .
VLANs are created using the set vlan command for COS devices or with the vlan command in vlan database mode for IOS switches.
For Ethernet VLANs, you can also configure the standard parameters in Table 6-1.
The 6513 has vlan A and B defined and Vlan B has a helper address as it works on other routers that use a different Vlan for management (don't ask).
The 3550 doesn't seem to be getting updates from the 6513. XFeature Mode Revision-------------- -------------- -----------VLAN Server 32Pruning : disabled VLANs prune eligible: 2-1000 The first thing I notice is that you are running two different versions, but I'm not certain that's the issue.
If VTP is not updating the VLANs correctly, check to make sure the MD5 digest on all VTP domain switches is the same.
The MD5 digest is calculated using the revision number, domain name, and password to make sure the information in the VTP update can be trusted.
C3750G-12S#sh vtp stat VTP Version : 2Configuration Revision : 20Maximum VLANs supported locally : 1005Number of existing VLANs : 28VTP Operating Mode : Server VTP Domain Name : HQVTPVTP Pruning Mode : Disabled VTP V2 Mode : Disabled VTP Traps Generation : Disabled MD5 digest : 0x8D 0x DB 0x96 0x3D 0x9E 0x E3 0x4C 0x31Configuration last modified by .1 at 10-31-08 Local updater ID is 1.1 on interface Vl51 (lowest numbered VLAN interface found)C3750G-12S#C3508G-XL#sh vtp stat VTP Version : 2Configuration Revision : 0Maximum VLANs supported locally : 254Number of existing VLANs : 11VTP Operating Mode : Client VTP Domain Name : HQVTPVTP Pruning Mode : Disabled VTP V2 Mode : Disabled VTP Traps Generation : Disabled MD5 digest : 0x D8 0x A5 0x36 0x6A 0x05 0x97 0x1D 0x56Configuration last modified by 1.106 at 10-24-08 C3508G-XL#HTH Viconsul Sometimes you need to trigger a VTP update to make them sync up.. I will get the trunk config when I get back to the office. Buck Weet Also need the configs from the trunk links. Add the vtp password and thats it , it should automatically pick up the vtp domain by itself if its going to work .
Sorry guys---I must have been thinking of root bridge priorities... The MD5 checksum doesn't match, so some paramter is incorrect. Below is the show version on the client switch (C3508G-XL)C3508G-XL#sh ver Cisco Internetwork Operating System Software IOS (tm) C3500XL Software (C3500XL-C3H2S-M), Version 12.0(5)WC17, RELEASE SOFTWARE (fc1)Copyright (c) 1986-2007 by cisco Systems, Inc.